Check your house

Is radon a problem in your Twin Cities home? Start here.

Radon gives no symptoms, so this guide works from what you can see and what you have measured: test results, the state of an existing system, and the house features that let soil gas in.

EmergencyUrgentSchedule serviceColor indicates response urgency

Never tested, and anyone uses the lowest level

Schedule service

Likely cause: Unknown. About 2 in 5 tested Minnesota homes hold a level worth fixing, so an untested house is a coin flip weighted the wrong way.

Run a short-term test this heating season on the lowest lived-in level.

Test result of 4 pCi/L or higher

Urgent

Likely cause: Above the EPA action level. Soil gas is entering faster than the house can dilute it.

Get a written mitigation scope from an MDH-licensed professional this season.

Test result between 2 and 4 pCi/L

Schedule service

Likely cause: Borderline. A summer result may understate the winter; a winter result is near the house's peak.

Run a long-term test across the heating season, or fix now if someone sleeps on that level.

Radon gauge reads level on both sides

Urgent

Likely cause: No suction. The fan has stopped, lost power, or the pipe is blocked, often by ice after a cold snap.

Check the breaker and the discharge outlet, then book a service visit if it does not recover.

Radon fan has started whining, rattling or gurgling

Schedule service

Likely cause: Worn bearings, a loose mount, or condensate trapped in a low spot of the pipe.

Plan a fan swap or pipe correction before it fails in deep cold.

Sump basket is open or the lid sits loose

Schedule service

Likely cause: A direct opening to the drain tile loop that collects soil gas around the whole foundation.

Test, and have the basket sealed with a gasketed, removable cover.

Radon pipe in the house but no fan and no recent test

Schedule service

Likely cause: A passive rough-in, standard in Minnesota homes built since 2009, that may or may not be enough.

Test the lowest level; if 4 or higher, add a fan to the existing pipe.

Existing system has no MDH tag and looks recent

Schedule service

Likely cause: Possibly installed outside the licensing rules that have applied since 2019.

Retest, and have the system checked against current practice.

Elevated result and a closing date on the calendar

Emergency

Likely cause: A transaction finding with a deadline attached.

Call now so the scope, install and verification test fit before closing.

Before you call

What to check yourself

  1. 1

    Find your last test

    Look for any radon report from a purchase, a kit, or a previous owner. Note the date, the season and the room.

  2. 2

    Walk the basement

    Look for a pipe with a U-shaped gauge, the MDH tag, an open sump basket, wide floor cracks, and old floor drains.

  3. 3

    Read the gauge

    Unequal liquid columns mean the fan is pulling. Level columns mean it is not. Photograph a normal reading for later.

  4. 4

    Check the outlet

    From the yard, look at the discharge above the eave. Frost or icicles after a cold snap can choke the system.

  5. 5

    Test if anything is uncertain

    A short-term kit in the heating season on the lowest lived-in level settles most questions for very little money.

When to call us

Call when a test reads 4 pCi/L or higher, when an existing system's gauge reads level and does not recover after the weather breaks, or when a home sale puts a deadline on any of it. Everything else on this page can be scheduled, and none of it calls for leaving the house tonight.

If you are experiencing any of these, call now:

  • Elevated result and a closing date on the calendar

Ready to get started?

About 2 in 5 Minnesota homes tested hold radon at levels worth fixing, by MDH's own count. Mon-Sat 8am-7pm.

Call (651) 317-5960Text us

Prefer to text? Open your texting app